-
11
-
8. Installation Guide
8-1 .PRECAUTIONS
z
Turn off the engine before installation.
Connect the main power of the device at last after installation. (
, here in after called
“Power”)
z
Insert SD Memory card before connecting the device.
z
Install the device in safe and bright place.
z
Connect the main power through cigar jack provided (DC 12V ~ 24V).
8-2. Installation
1. Attach the device
Check and select the proper place where does not disturb driving
on the front window and attach the device with a double faced tape.
2. Fix the device
Get the camera lens focused on the front and fix with Lock
Screws of the device.
★
GPS reception part should be exposed to the window for the
better reception.
3. Connect the power
Connect the cigar jack to the power port and check if the power
is working properly.
★
SD Card should be inserted before connecting the power.
Otherwise, Red and Green LED would be blinking at 0.5sec
interval by turns.
4. Calibrate G-Sensor (Acceleration Sensor)
Press “Down” for 3 seconds when power is on, and calibrate G-Sensor
value. (Check if Red LED is blinking at 0.1sec interval rapidly for a
second.)
★
When calibrates G-Sensor, put the device on flat place.
When changes the place to attach the device, calibrating
should be
