J.ASSY VISUM Monitor, Operator'S Manual

Page: 18 / 42

18
| J.ASSY
After addressing the sensor, the monitor shows the
message
“Ok” on the display and turns on the LED
corresponding to the sensor type in green, the user
needs to confirm the addressing by clicking .
When the addressing is successful, the monitor will go
to the row selection with the incremented value of 1, that
is, if the addressing of row 3 was successful, it will now
be ready to address row 4, waiting only for the user’s
confirmation by same procedure.
F6 | Display the monitor ID
Upon entering the function, the monitor will begin the
process of presenting the ID.
Upon entering the function, the monitor will show its own
ID.
On this screen, the monitor will keep the two LEDs off
and present ID information on the display, with an
interval of 1 second, in the form:
OUTPUT CONDITIONS:
The user can cancel the addressing process
at any time by pressing the for 5 seconds,
and the monitor will return to the row selection
screen, if is pressed again for 5 seconds
the monitor returns to the device’s operation
screen.
OUTPUT CONDITIONS:
After presenting the data, the monitor should
exit the function.
The user can cancel the process at any time by
pressing
for 5 seconds.
The maximum time to remain within this
function is 60 seconds.