VISUM
|
33
2- Enter the desired row for the sensor
3- Select
“ADDRESS” and follow steps to address the sensor:
a. Find the address indicator
on the rubber cover.
b. Wake up the sensor by shaking it.
c. Place the magnet on the address indicator (make circular
movement to easily turn on the internal switch).
d. Wait for the confirmation beep or message.
e. Fill in the address indicator with the number of the
implement and row on the sensor.
4- When the process is concluded the progress bar and a
message
“ADRESSED” will show in your VT.
5 - Add the new sensor number
6 - Repeat the process until all sensors are adressed
ATTENTION:
If you forget to increase the sensor number, two
sensors might be confirmed on the same row.
just adress one of them again with the correct row
number.
Summary of Contents for VISUM Monitor
Page 1: ...OPERATOR S MANUAL...
Page 42: ...www jassy ag January 2022...
