14
/16
System Operation Manual - IZIP E3 Twn:exp
03/10/14
The display’s electrical system functions
The display shows information about the bike’s electric assist, and gives the rider access
to several important functions:
Assist level
The current assist level is shown on the display (assist level indicator).
Battery level
The battery level indicator shows the current charge level of the battery. Each bar
represents about 20% capacity.
The low battery warning indicator
lights up when the battery has
less than 5%
remaining
charge.
Maintenance information
The maintenance indicator
lights up when there is a system error. An error code shown
on the display helps to diagnose the problem. See “Error codes” below.
Control pad functions
The control pad is used to control the various functions of the bike and display.
The control pad’s five buttons perform the following functions:
CONTROL PAD FUNCTIONS
Cycle assist level 1–4, and “T”/throttle-only mode.
Turn on display backlight and the headlight and taillight if installed.
When bike is off, and battery is turned on:
Turn bike on
When bike is on, and in assist level
1
–
4
:
Set assist level 0
When bike is on, and in assist level
0
:
Turn bike off
Change cyclecomputer display
Activate cruise control
The display backlight and any attached headlight/taillight is also controlled by the ambient
light sensor; they will automatically turn on in low light.
