8
/8
System Operation Manual - IZIP E3 Peak
11/27/13
Charging issues
ISSUE:
Charger LED indicator flashes red
LED flashes red after charging for a while:
Battery is not responding to charging.
•
The battery voltage is less than 25V, and does not rise
above 25V after 30 minutes of charging.
•
The battery voltage is between 25V and 30V, and does
not rise above 30V after one hour of charging.
Solution
Reset charging by unplugging the charger
from the wall outlet, then plugging it back
in. If charging fails after a second attempt,
the battery or charger may need to be
replaced. Bring them to your dealer for
inspection.
Battery has not finished charging after 10 hours.
Solution
The battery may be damaged and should
be inspected by your dealer.
LED flashes red immediately after being plugged in:
The polarity between the charger and battery does not
match.
Solution
The battery or charger may be damaged.
Stop using the battery and charger
immediately, and bring them to your dealer
for inspection.
The output of the charger is short-circuited.
Solution
Stop using the battery and charger
immediately. Check for obvious external
shorts on the charging plug and battery
charging port. If no obvious short exists,
the battery or charger may be damaged.
Bring them to your dealer for inspection.
Other issues causing a flashing red LED:
The temperature of the battery is too high to charge.
Solution
Put the battery and charger in a cool place,
then try charging again after a few minutes.
ISSUE:
Charger LED indicator
stays green when plugged
into the battery.
There is no connection between the charger and the battery.
Solution
Check for damage: battery charging port,
charging plug, charging cord, and power
cord
.
There may be an internal problem with
the battery or charger. Bring them to your
dealer for inspection.
The battery’s voltage is too low to be charged.
Solution
Check the battery’s charge level as
described in this document. If the battery
will not turn on, the battery may be
damaged and should be inspected by
your dealer.
Misc issues
Lost key
If you have lost your keys, note your bike’s serial number
(
located on the frame’s left dropout
) then call Currie Tech
customer service at (800) 377-4532.