CAN@net II/Generic, Version 1.5
ASCII Protocol Short Reference
38
Device Messages
Command
Parameters
D VER
-
D PROTO
-
D CONFIG SAVE
-
D RESET
-
Information Messages
C Command
Info Message (response to controller command)
C INIT
I OK (CAN controller is initialized [XYZ])
I CAN init command received. Autobaud success:[XYZ]
C INIT CUSTOM
I OK (CAN controller is initialized [XYZ])
I CAN init command received. Autobaud success:[XYZ]
C START
I OK (CAN started)
C STOP
I OK (CAN stopped)
C RESET
I OK (CAN reset)
C STATUS
I CAN status command received
I CAN status [Bus off] [Error Warning] [Data Overrun]
[Init Mode]
Note: all [XYZ] are optional
C FILTER ADD
I OK (ID 0xX added to filter list)
C FILTER REMOVE I OK (ID 0xX removed from the filter list)
C FILTER SEARCH I OK (ID 0xX found in the filter list)
C FILTER CLEAR
I OK (CAN filter cleared)
C FILTER ENABLE I OK (CAN filter enabled)
C FILTER DISABLE I OK (CAN filter disabled)
C FILTER LOAD
I OK (CAN filter loaded from flash)
C FILTER SAVE
I OK (CAN filter saved to flash)
C FILTER SHOW
I Filter List is empty
I CAN filter show command received. Filter list is
[Enables/Disabled] and contains X IDs:
I 1 2 3 4 5 6 7 8 9 a b c d e f 10
I 11 12 13 14 15 16 17 18 19
