IWILL P4R533, User Manual, Page: 58 / 104

P4R533/P4R533-N Motherboard
○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○
User’s Manual 4•12
○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○
Installing the Motherboard in a System Housing
This section explains the basic requirements for install-
ing this motherboard in a system housing or “chassis”.
Since housing designs vary widely, you will need to con-
sult the housing documentation for specific information.
This motherboard can be installed in any housing that
supports the ATX form factor.
To install the motherboard in a system housing you will
need to do the following:
• Install a rear I/O panel shield
• Attach the board to the housing
• Connect leads from the housing’s front panel
You can then connect other internal system components
as described later in this chapter.
Motherboard Installation Procedure
This section assumes you are installing the board in a
suitable ATX housing. We also assume you have pre-
pared the board for installation as previously described
in this manual. If the housing you are using normally
stands vertically, place the open housing on it’s side be-
fore you start.
Please follow this procedure to install this motherboard:
1. Review any instructions that came with the system
housing and prepare the necessary mounting hard-
ware that came with it.
2. Identify the mounting holes on the board and con-
firm that the housing has standoffs that match them.
3. Install the rear I/O panel shield that came with the
motherboard in the housing’s I/O panel opening.
This should fit in the housing .
4. Insert the board in the housing and align the mount-
ing holes to the standoffs on the housing’s
motherboard mounting plate. Make sure all of the
rear I/O ports are properly aligned with the open-
ings in the I/O panel shield.
5. Attach the board to the housing by inserting mount-
ing screws in all the holes and tightening them
snugly.
Required Tool:
• Philips-head screw driver
(Crosshead)