IWILL P4R533, User Manual, Page: 25 / 104

2: Key Features & Components
○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○
User’s Manual 2•11
○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○
The system fans use the motherboard fan speed control,
which consists of three states: Off, Normal speed, and
High speed. In Normal speed mode, the system fans run
at normal speed until the thermal sensor senses the tem-
perature exceeds the High speed fan threshold tempera-
ture. The system fans then run at High speed when the
temperature threshold is exceeded.
More Information: Please see the PC Health Status sec-
tion of “Configuring the CMOS Setup Utility” in Chapter
5 for information.
WOL: Wake On LAN Connector J46
Function: A connector for the lead from a Network Inter-
face Card that supports the Wake On LAN feature.
Description: This feature enables the system to “wake
up” from Suspend mode when it receives a signal over a
LAN it is connected to. It works with the optional onboard
LAN port and will also work with an additional PCI NIC
that supports this feature by connecting the card to the
WOL connector on the motherboard.
More Information: Please see the Power Management
Setup section of “Configuring the CMOS Setup Utility”
in Chapter 5 for information.
Fan power connectors
(orientation varies)
Cooling Fan Connectors:
The cooling fan power
connectors all use the
same 3-pin connector. The
System Fan connectors are
speed controlled, the CPU
Fan connector is not.
Wake On LAN Connector:
This connector is for an
additional NIC. The op-
tional onboard LAN port
supports WOL without us-
ing this connector.
Wake On LAN connector