IWILL P4G Series, User Manual

Page: 36 / 110

P4G Series Motherboard
○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○
User’s Manual 2•22
○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○
LAN Port
Function: Connecting a CAT 5 LAN cable to the system.
Description: This is an RJ-45 connector for standard Cat
5 LAN cabling with RJ-45 jacks. The connector is for the
onboard RealTek 8100 LAN controller. You can connect
or disconnect a LAN cable when the system is turned on.
More Information: See the System Features section of
Chapter 6 for information LED modes.
RJ-45 LAN jack
LAN RJ-45 Jack:
Right LED = Activity
Left LED = Link
USB Ports
Function: Connecting USB 2.0 devices to the system.
Description: These are Hi-Speed USB 2.0 ports for con-
necting either USB 1.1 or 2.0 devices. The ports are for
“Type A” USB cable connectors. You can connect or dis-
connect USB cables when the system is turned on.
More Information: See the Integrated Peripherals sec-
tion of “Configuring the CMOS Setup Utility” in Chapter
5 for information on adjusting port settings.
USB ports 1, 2, 3
USB Ports:
There are three USB ports
on the rear panel. The
JUSB3 USB port shares a
root hub with the third
external USB port.
Note:
You must install the sup-
plied USB 2.0 drivers for
use with Windows 2000 or
Windows XP or the USB
ports will only work in USB
1.1 mode. Other operating
systems are not supported.