SYN
HU
EN
3-2. Wire Feeder Control Panel
A
Digital Voltage display
B
Digital Current display
C
Gas Type selection button and status indicators.
D
Wire Diameter selection button and status indicators.
E
Gas Check button
- Press the gas inspection button to open the gas valve for 30 s without starting
the wire feeder and welding equipment. Press the button again to stop feeding
gas.
F
End-current/Spot-time/Spot-interval time
Select the desired parameter and set it with “G” knob.
G
Adjusting knob - adjust the selected welding parameter
H
Voltage/Inductance/End-voltage adjustment
Select the desired parameter and set it with “G” knob.
I
Wire check button.
-Press manual wire feeding button to start the wire feeder Only the motor of wire
feeder will feed the wire. The current adjusting knob can be used to adjust the
wire feed speed. Release the manual wire feeding button to stop feeding.
J
Operation mode selection (2T/4T/2TSD/SPOT) button and status indicators.
K
Synergic/Manual mode selection button
A
B
C
H
G
F
D
E
K
J
I
23
