Ivoclar Vivadent Bluephase G4, Instructions For Use Manual

Page: 14 / 184

14
Observe the Instructions for Use of the material
applied when selecting the curing time and intensity.
The curing recommendations for composite materials
apply to all shades and, if not mentioned otherwise in
the Instructions for Use, to a maximum layer thickness
of 2 mm. Generally, these re commendations apply to
situations where the emission window of the light guide
is placed directly over the material to be polymerized.
Increasing the distance between the light source and
the material will require the curing time to be extended accordingly. For instance, if the distance
to the material is approx. 11 mm, the effective light
output is reduced by approx. 50%. In this case, the
recommended curing time has to be doubled.
1) The information provided herein applies to the
10 mm light guide supplied in the delivery form.
2) The information regarding heat development and
burn hazards must be taken into consideration
(see Safety notes).
Curing times
HIGH POWER
1,200 mW/cm
2
Restorative materials
Composites
• 2 mm
1)
IPS Empress Direct / IPS Empress Direct Flow
Tetric EvoCeram / Tetric EvoFlow
Tetric / Tetric Basic White 10 seconds
• 4 mm
2)
Tetric PowerFill / Tetric PowerFlow
Tetric Basic White 10 seconds
Heliomolar / Heliomolar HB / Heliomolar Flow
All conventional composites
1)
15 seconds
Compomer
3)
Compoglass F / Compoglass Flow
20 seconds
Indirect restorations /
cementation materials
Variolink Esthetic LC
4)
/ Variolink Esthetic DC
5)
per mm ceramic:
10 seconds per surface
Multilink Automix
5)
/ SpeedCEM Plus
5)
per mm ceramic:
20 seconds per surface
Adhesives
Adhese Universal
ExciTE F / ExciTE F DSC
Heliobond / Syntac
10 seconds
Temporary materials
Telio CS Link
Telio CS Inlay/Onlay
Telio Stains
Telio Add-On Flow 10 seconds per surface
10 seconds
10 seconds
15 seconds
Miscellaneous
Helioseal F Plus 10 seconds
IPS Empress Direct Color
IPS Empress Direct Opaque
MultiCore Flow / Multicore HB 20 seconds
20 seconds
20 seconds
1) Applies to a maximum layer thickness of 2 mm and provided that
the Instructions for Use of the respective material do not state any other
recommendation (might be the case e.g. with dentin shades)
2) Applies to a maximum layer thickness of 4 mm and provided that
the Instructions for Use of the respective material do not state any other
recommendation (might be the case e.g. with dentin shades)
3) Applies to a maximum layer thickness of 3 mm
4) Applies to light-curing
5) Applies to dual-curing