- 13 -
Attention:
The adaptor equiped can only be placed indoor or in water-proof box or other water-proof spaces, it can not be
placed directly outdoor, otherwise water may seep in and damage the adaptor.
F. Put up the wall bracket assembled with IR Low-speed dome on the ancillary hooks: Pull the power cable, video cable
and controlling cable out through the wire-out-going hole of the bracket, then put the assembled on the two corresponding
pegs on the installed peg-board, then push the bracket downward until it locks in place. Make sure the wall bracket is well
fixed with the installation board, then direct the screw on the bracket to the corresponding hole on the lower part of the
installation board and tighten the screw.
5.3.2 Connection of Exterior Cables
Connect BNC video outlet of the IR Low-speed Dome Camera with the already disposed video cable, the power cable
with the already disposed power cable (DC15V) and RS485 controlling cable with already disposed RS485 controlling
cable. The cables of IR Low-speed dome camera is shown below:
Cable
Application
Connecting Objects
Remarks
Power cable
DC15V
power supply
IR Low-speed dome---
power supply adaptor
Inner positive, outer
negative
485 cable
485 controlling
signal
IR Low-speed dome
--- controlling device
Green (A), white(B)
Video Cable
video signal
IR Low-speed dome
---monitoring device
Inner positive, outer
negative
Earth
connecting
port
Connecting
the
earth
for
lightening proof
IR Low-speed dome
--- the earth
Black cable
◆
When connecting, make sure the polarity of RS485 controlling cable is correct: A: RS485 positive, B: RS485
negative.
◆
If wrongly connected, the IR Low-speed Dome Camera will be out of control.
5.3.3 Switch on Power
a Make sure the polarity of plugs, sockets and the connection of cables is correct, then switch on power
b The IR Low-speed Dome Camera begins to do the self-check: it moves pan 360°, tilt 90°, then moves to its original
position, then zooms in and zooms out once. Through the self-check, the unit checks the mechanical moving performance
of the pan/tilt, the electrical performance of the controlling system, the controlling of the camera module. After the IR
Low-speed Dome Camera finishes self-check, it stays at the original position and is ready to receive controlling
instructions.
