Operator Weighing Procedure
The
Mode 8
shown on LED display is always the
starting point to initiate a weighing cycle
Weighing Loads
When power to the vehicle is turned on the LED display
should show software version.
(Example: Software version 1500)
If the LED display is not showing any digits make sure the
power on / off switch
located on top of the instrument
enclosure is on.
1.
Insert the forks into the pallet or under the product to be
weighed.
2.
Lower the forks to the ground.
LED display must show Mode 8 to initiate the “weighing
cycle”.
3.
Activate and hold the lift control button
. LED display
will go blank for the moment, audio will be activated
during the measurement.
The “weighing cycle” will be initiated and the system will
automatically stop the lift cylinder when ready and load weight will be shown.
Audio will be deactivated.
The lift cylinder will be operational once the load weight is shown on the LED display.
Mobile Wireless Bluetooth Printer
The SkidWeigh ED2-EP / DL2-EP Elite series can be
ordered to support Bluetooth mobile printers. The automatic
Bluetooth pairing is done by holding down
Arrow Up
and
turning power on to the system.Within few seconds the LED
light (Blue) will come on and stay on indicating that pairing
with mobile printer is completed.
Accumulative Load Weight Function
SkidWeigh ED2E-EP-AT / DL2E-EP-AT
Units equipped with the AT, accumulative totalling function, utilize
Integrated Visual Data Technology Inc. 3439 Whilabout Terrace, Oakville, Ontario, Canada L6L 0A7
