Method B.
Use the two b
lack wires and splice them in series with one of the lift pump solenoid coil wires activating the
pump motor.
Disconnect one of the original solenoid coil wire
( From either positive or negative terminal of the solenoid coil )
and splice the two bLACK wires in series to the
disconnected wire and solenoid terminal.
Note:
The predetermined motion of the lifting cylinder and the load weight measurement “weighing cycle” will be initiated
and controlled automatically by the specific software algorithm based on the input from the pressure transducer signal.
(With the vehicle at a stationary position during the lifting cycle diagnostic display on some vehicles may
show ‘No power to lift motor’ or audio signal might be activated for short time period.)
Unloaded vehicle is
motion may produce hydraulic spikes that are detected by the pressure transducer sending a signal this may
be seen by the vehicle controller as starting the “weighing cycle”. Short interruption of the power to the lift
solenoid coil on
some controllers
are
seen as a fault and power to the vehicle will be cut.
SkidWeigh ED2E-EP / DL2-EP Power O
ff
When weighing function is not required and to avoid interruptions due to
lift cut outs simple turn the system o
ff
Pressure Transducer Installation Precautions
Before installation of the pressure transducer the hydraulic lift circuit must be
pressure free.
Make sure that the installed pressure transducer will not touch any moving parts or
vehicle assembly once installed while in normal operation. The pressure
transducer has a
1/4”-18 NPT male thread
. Use thread seal to ensure tight fit.
Integrated Visual Data Technology Inc. 3439 Whilabout Terrace, Oakville, Ontario, Canada L6L 0A7
Power On / Off Switch
