Water drainage
1. When in dry mode, remove the drain plug from the back of
the
unit.
2. Install the drain connector with the continuous drain hose,
placing the open end of the hose directly over the drain area.
Care and maintenance
Before performing any maintenance always keep in mind the following:
•
Always unplug the unit before cleaning or servicing.
•
Never use flammable liquids or chemicals to clean the unit.
•
Do not wash the unit under running water. Risk of electric shock.
Cleaning the filter
1. Remove the filter as shown.
2. Wipe away any collected debris and replace.
The filter should be cleaned every 2 weeks for optimal performance.
Cleaning the unit
1. Clean the unit with a damp cloth and mild detergent.
2. Dry with a lint-free cloth.
Storing the unit
1. Drain the water collection tray before putting the unit into storage.
2. Run the unit in fan mode for 12 hours in a warm room. This will dry the unit and prevent mold.
3. Turn off and unplug the unit.
4. Clean the filter as instructed above.
5. Remove the batteries from the remote controller.
6. Store the unit in a cool, dark place. Keep out of direct sunlight and extreme heat.
3. When the collected water reaches the maximum level, the unit
will beep 8 times and the digital display will read P1. The unit will
stop dehumidifying until the collection tray is emptied.
4. After emptying the collection tray, restart the unit.
6
Remove the
drain plug
Continuous
drain hose
Bottom drain
plug
Remove the air filter
Air filter
(take out)
Auto-restart
If the unit stops unexpectedly due to a power cut, it will restart with the previous function setting 3 minutes after the
power resumes.