Control panel
1.
Mode button:
use this button to cycle through modes (cool, fan, dry). The indicator light will illuminate to show which mode the
unit is currently in.
2.
+ / - buttons:
use these buttons to increase or decrease the temperature setting by 1°F/1°C increments. The temperature can be
adjusted from 62°F (17°C) to 86°F (30°C). To switch from Fahrenheit to Celsius, hold down the + and – buttons for 3 seconds.
3.
Power button:
powers the unit on or off.
4.
LED display:
shows the set temperature while on cool mode. Shows current room temperature while on dry or fan mode. If
“P1” is displayed, the bottom tray is full and must be drained.
5.
Cool mode:
a. Press the mode button until the indicator light next to COOL turns on.
b. Press the + or – button to adjust the temperature.
6.
Fan mode:
a. Press the mode button until the indicator light next to FAN turns on.
b. Press the fan speed button on the remote controller to choose the fan speed. The temperature cannot be adjusted while in
this
mode.
7.
Dry mode:
a. Press the mode button until the indicator light next to DRY turns on.
b. When in this mode, the fan will be set to the lowest speed and the unit will act as a dehumidifier.
8.
Sleep mode:
NOTE: this mode is unavailable during fan or dry mode.
a. Use the remote controller to activate sleep mode.
b. When this mode is active, the temperature will increase by 2°F/1°C after 30 minutes. Then the temperature will increase
again by 2°F/1°C after another 30 minutes.
c. The new temperature will be maintained for 7 hours before returning to the previously set temperature.
d. After this cycle, sleep mode will automatically end.
5
4. Install the security bracket with
2 screws as shown (optional).
NOTE: do not overextend, bend, or block the hose. This
will prevent the air conditioner from functioning properly.
5. Insert the window slider adapter
into the hole of the window slider.
2 Screws
Security
Bracket
1
2
2
4
7
6
5
3