IVAC 218X, Manual

Page: 21 / 25

NOTE: Betadine may discolor
the case. Use 10% solution of
bleach to remove
discoloration. Apply the above
solutions with a dampened
sponge, soft brush, or a cloth,
then wipe dry with a clean
cloth or towel.
NOTE: ALARIS Medical Systems
does not recommend EtO
sterilization of the Model
2180/2185 Series
thermometers.
MAINTENANCE
17
Maintenance
It is good practice to periodically clean the instrument surface by
wiping it with a soft cloth dampened with a mild detergent and
warm water. Refer to Housekeeping, Central Service or Infection
Control departments in your facility for further information.
You may use the following cleaning solutions: Cidex® *,
Betadine®, 10% solution of bleach (9 parts water, one part
bleach), 3% Hydrogen peroxide.
If you currently use a specific cleaning agent or disinfectant, we
recommend that you examine its chemical ingredients prior to
use on the thermometer. If you question the effect your specific
cleaning agent or disinfectant has on your instrument, contact
your local ALARIS Medical Systems sales and service office or
distributor.
* Cidex is a registered trademark of Surgikos, Inc. Betadine is a registered trademark
of Purdue-Frederick.
DO NOT USE ALCOHOL, AMMONIA, OR AMMONIUM
CHLORIDE BASED AGENTS as they could damage the plastic
exterior of the instrument.
Do not allow fluids to enter the instrument. Fluid leakage into
the instrument can cause damage.
Do not autoclave or immerse the TURBO TEMP™
Thermometer as damage will occur.
If the IVAC ® TURBO TEMP™ Electronic Thermometer fails to
perform as indicated by the Directions for Use or performs
erratically and the cause cannot be determined,
DO NOT USE
THE INSTRUMENT . Refer to qualified service personnel.
To obtain service, application information, replacement parts,
circuit diagrams, component parts lists, descriptions, calibration
instructions, technical manuals or the location of authorized
distributors, please contact your local ALARIS Medical Systems
office located on page 20 of this document. When requesting
service, please be sure to include a description of the error
message or difficulty experienced. Should it be necessary to
return the product for service, carefully package the instrument
and both probes (preferably in the original packaging), and
return to the appropriate service or distribution center. ALARIS
Medical Systems cannot assume any responsibility for loss of or
damage to returned equipment while in transit.
*
Cleaning
Cautions
Service Information
CLEANING
*