ORBITALUM TOOLS GmbH
D-78224 Singen www.orbitalum.com
[REV. 20200320] OC_PS_BA_790048761_00__INH-02_EN
54
Transport and assembly
PS 4.5 PLUS
eNGLISH
WARNING!
Flying parts/breaking tool!
Diverse physical injuries and material damage.
X
Do
not
process the tube while it is loose in the vice.
X
Never
use a damaged or deformed saw blade.
X
In the event of tool breakage with a new tool, do
not
enter the old cut because the tool
can break again.
X
Clamp the tube to be cut into the vice.
X
Immediately replace worn-out tools.
X
Ensure that the cutting tools are correctly fitted.
X
Tube dimension must be set correctly. During cutting, the saw blade must saw through
the entire tube wall.
X
Avoid breaking tool through low (adequate) feed force, correct dimension (see chap. 8.7,
p. 55) and speed (see chap. 8.8, p. 56) settings.
X
Hold on to the motor unit tightly by the handle, and guide it with low (adequate) feed
force during the machining process.
NOTe!
It is only possible to mount or replace the saw blades if
no
tube has been clamped into the vice
before. If necessary, remove the tube before mounting the saw blade (see chap. 8.7, p. 55).
1. Remove the cover (1).
2. Loosen the clamping screw (2) by using the Allen key.
3. Remove the saw blade.
4. Clean the saw blade shaft and the surrounding by using a brush.
1
2
ATTeNTION!
Damage to material!
X
The saw blade must be free from chips and dirt.
X
Only use Orbitalum Tools saw blades.
X
Mount the saw blade with the inscription pointing to the saw blade guard.
The teeth are now arranged in the correct direction .