6.4.8 Disassemble the radial end (sleeve/tilt pumps)
Figure 53: Radial end (sleeve/tilt) disassembly
1.
Remove all instrumentation from the upper and lower half bearing housing (134). Plug any open
connections.
2.
Remove oil feed piping from the lower half bearing housing (134).
3.
Remove drain piping from the lower half bearing housing (134)
4.
Remove the two taper pins between the upper and lower half of the bearing housing (134).
5.
Remove the hex cap screws that connect the upper and lower half of the bearing housing (134).
6.
Tighten the two jack bolts on the horizontal parting flanges of the bearing housing (134) in order to
separate the two halves.
7.
Remove the top half of the bearing housing (134).
6.4 Disassembly
3610 i-FRAME API 610 11th Ed/ISO 13709 2nd Ed, API Type BB1 Single-Stage, Axially-Split, Between-Bearing IOM
77
Summary of Contents for 3610 i-FRAME
Page 2: ......