ITT Industries Goulds Pumps 3196, Installation, Operation And Maintenance Instructions

Page: 27 / 52

Application Instructions
The Polyshield
®
VE Sealing Kit is intended for use in
(1) bonding the plug into the grout hole at the top of
the combo and (2) sealing and providing chemical
resistance barrier around the perimeter of pump pad.
1. All surfaces to be bonded should be thoroughly
cleaned and should be free of dust, oils and
contaminants. Sand surfaces to be bonded prior
to use.
2. Pour Polyshield
®
VE Hardener #1 into the
Polyshield
®
VE Resin can. Mix well with stir stick
for about two minutes.
3. Apply to properly prepared surface by stir stick or
putty knife.
4. Use MEK, Xylene solvents for cleaning tools and
equipment and for lightly brushing surface to
provide a smooth finish.
Safety Precautions
s
! WARNING
Resin and hardener components may be
irritating to the eyes and skin on contact.
Vapors may cause irritation of eyes and
respiratory tract. Area must be ventilated.
Wear protective clothing including gloves. For
details on safety information, refer to the
Material Safety Data Sheets of these products.
Shelf Life and Storage
Store resin and hardener in their unopened
containers in a dry cool place away from open flames,
heat or sources of ignition. Shelf life is limited to 60
days if stored in a cool, dry location.
Polyshield
®
Seal Kits provide sealant for every ANSI
Combo. Polyshield
®
Seal Kits are shipped with each
ANSI Combo.
Fastener Size and Recommended Torque Values
Fastener
Standard
Fastener
Nominal Size
Recommended
Torque 1
lb.-ft.
SAE
5
16
6
3
8
10
7
16
18
1
2
27
5
8
53
3
4
94
7
8
152
1 228
1
Torque values shown for SAE fasteners are
based on dry threads at 75% of proof load for
ASTM307 Grades A and B (SAE Grade 1)
fasteners.
For lubricated, plated, or PTFE coated threads,
use 75% of torque values shown.
Polyshield
®
is a registered trademark, U.S. Patent Nos. 5165651, et. al, apply.
ANSIFAM IOM - 12/03
27
3