Programming
PanDoor Installation and Programming Manual
15
Note
If an incoming call comes through the PSTN during the
programming process, a Call Waiting signal will sound.
If you switch to answer the call, the completed
programming settings are saved automatically.
To exit the programming mode:
•
Dial
*900
.
•
Hang up.
•
Timeout (default value: 45 seconds).
•
Switch to another panel or controller.
Note
It is necessary to hang up between door panel
programming and entering a controller.
3.1
Programming Code Guide
The following programming guide provides a list of all possible
operations, commands and default values.
Operation
Command
Default
Access code
Unit:
Panel
*110 + XX + YYY…+#
where:
XX = Access code number
(00-99)
YYY…= New Access code
(2-6 digits)
Note
:
The capacity of access codes is 100
entries per panel.
00=9876
