Restart the computer by pressing the
Power Button
for at least eight seconds. If the problem persists,
contact your supervisor or your organization's help desk.
Press the F1 key to resume
This message indicates that an error was found during POST. Pressing the
F1
key allows the system to
attempt to boot.
CPU Fan Error
Report the error to your supervisor or your organization's help desk.
Battery too low to warm the hard drive. Shutting down...
There is not enough battery power to operate the Hard Disk Drive (HDD) heater and the temperature is
too cold to safely turn on the HDD. Apply external power and/or move the unit to a location that is at
least 5°C.
Warming internal hard drive. Please wait...
The temperature is less than 5°C and the HDD heater is operating. The unit will continue booting when
the HDD temperature is warm enough for safe operation.
72_0119_001
28 June 2004
© 2004 Itronix Corporation. All rights reserved.
MS-DOS Messages
The
MS-DOS
operating system may display a warning or error message if it encounters a problem with
a command in the CONFIG.SYS or AUTOEXEC.BAT file, or a command that you entered at the DOS
prompt. Following are a few of the most common MS-DOS messages.
Bad command or file name
A command was entered that is spelled incorrectly or does not exist on the computer.
Invalid media type reading drive X (where X is any drive letter)
GoBook III
®
Help
Page 67 of 80
GoBook III Help
7/5/2004
file://C:\Documents%20and%20Settings\harwoodm.ITRXNT1\Local%20Settings\Temp\~h...
