Chapter 4 Programming and Verifying 60WP Endpoint Operation
32
Water Solutions 60WP Endpoint Installation Guide
NOTES!
•
The 60WP Endpoint will remain in Programming Mode for 15 minutes. After
15 minutes you can reactivate Programming Mode using the magnet.
•
If the magnet is held in place longer than 15 minutes, remove the magnet for
three seconds and then put it back into position to reactivate Programming
Mode.
•
Endpoints that have been factory programmed will still require activation with
the magnet before they will detect register pulses. The one exception to this
rule is units that have been placed in the "Quite Mode". For more information
see
Operating Modes
on page 8.
Programming the 60WP Endpoint
To program a 60WP Endpoint, use an FC200SR handheld running the Itron Endpoint-Link
or Endpoint-Link Pro software and loaded with the endpoint programming configuration
file.
With the handheld, enter the endpoint ID, select the endpoint type (60WP), select the
correct meter configuration, select the length of the cable, and enter in the initial reading
from the register. When the is successfully programmed, the endpoint enters Normal Mode
and operates as programmed.
NOTES!
•
The FC200SR is the only handheld that supports programming for the 60WP
endpoint.
•
The endpoint and programmer should be a minimum of 12 inches apart while
programming.
•
Do not place the programmer antenna directly on the endpoint.