Ithaca PcOS series 90plus, Programmer'S Manual

Page: 136 / 180

Product Self Tests PcOS Series 90PLUS Programmer's Guide
Page 124 Rev M 12/16/99
8 lpi
•
Recommendation
Automatic
line feed
An automatic line feed feature can be set as a default
where all [CR]’s will have a [LF] added. If automatic line
feed is set to “on,” the feature is activated.
Off
•
On
Automatic
carriage
return
An automatic line feed feature can be set as a default
where all [LF]’s will have a [CR] added. If the automatic
carriage return is set to “on,” the feature is activated.
Off
•
On
Form length The default form length can be set from 3 to 17 inches.
This configuration affects how the [FF] command operates.
3 to 17 inches 11
Paper out
mode
The paper out features of this printer can be configured in
one of four ways.
1. Disabled - which prevents the printer from detecting the
end of the receipt paper
2. Fault - which sets a PE fault as soon as paper low is
detected
3. No warning - which sets PE to fault after a set length of
paper is fed and paper low is detected
4. Warning - which warns the operator when paper low is
detected and then sets PE to fault after a set length of
paper is fed.
Disabled
Fault
No warning (but is measured)
Warning
•
Receipt paper
In “no warning” or “warning” modes, the length of receipt
paper that is fed after paper low is detected is measured.
When a set length is reached the printer will insure a PE
fault. The receipt paper setting specifies the length of
receipt paper that is fed. The length can be set to 1 foot (30
cm); 1-ply (about 8 feet or 244 cm); 2-ply (about 4 feet or
122 cm); or 3-ply (about 2 feet or 61 cm). This should be
specified based on the type of paper you are going to use.
1 foot from warning to PE
1-ply
2-ply
3-ply
Slip top
adjustment
The position of the top of the form is adjustable from -8/72
to +7/72. The adjustment compensates for form variations.
-8/72 to +7/72 in 1/72 intervals (Default is 0). 0