Operating Other Components Using Remote Controller
44
3.
With the number buttons, enter the 5-digit remote control
code within 30 seconds.
•
The registration is complete when the remote
indicator flashes twice. The remote indicator flashes
once slowly when registering the remote control
code fails. Try the registration again.
Remapping the Colored Buttons
The colored button assignment on the AV receiver's remote
controller can be remapped to match that on the remote
controller of the component whose remote control code you
programmed to Remote Mode. However, you will not be
able to remap the colored buttons if Zone 2 is selected.
1.
Hold down the Remote Mode button to map and A (Red)
simultaneously until the remote indicator stays lit (about
3 seconds).
•
Remapping is possible only for codes included in the
categories of the Remote Control Code List such as
DVD player and TV.
2.
Within 30 seconds, press the colored buttons from left to
right, in the order you want to remap.
•
For example, if the colored buttons on the remote
controller of the other component are yellow, green,
blue, and red from left to right, press the buttons on
the AV receiver's remote controller in that order.
•
The registration is complete when the remote
indicator flashes twice. The remote indicator flashes
once slowly when registering the remote control
code fails. Try the registration again.
•
Pressing any other button than a colored button
cancels the remap operation.
Resetting the Remote Mode Buttons
You can reset the remote control code registered in the
Remote Mode button to its default status. This operation
can be executed on a single Remote Mode button.
1.
Press Home for 3 or more seconds while holding down
the Remote Mode button you want to reset.
•
The remote indicator stays lit.
2.
Within 30 seconds, press the Remote Mode button
again.
•
Resetting is complete when the remote indicator
flashes twice.
To reset all the remote controller settings
: While holding
down RCV, press and hold down Home until the remote
indicator lights (about 3 seconds). Press RCV again within
30 seconds. Reset is complete when the remote indicator
flashes twice.
TV Operation
Press the Remote Mode button programmed with the
remote control code for the relevant AV component to
switch the remote controller mode to that for the AV
component. Then, operate by using the corresponding
buttons. Available buttons vary depending on the product
category of the component. Operation may be incorrect or
impossible depending on the product.
1
2
3
4
1
Remote Mode
2
, Input, VOL /
3
Muting
4
CH +/-
5
7
8
9
F
6
5
Guide
6
/ / / , Enter
7
Setup
8
PREV CH
9
Return
F
Audio (
)
