![background image](http://html1.mh-extra.com/html/itech/it8500plus-series/it8500plus-series_manual_2095282008.webp)
8
BDH
Enquire the voltage upper limit in CP mode
BEH
Set the voltage lower limit in CP mode
BFH
Enquire the voltage lower limit in CP mode
C0H
Set the max input resistance
C1H
Enquire the max input resistance
C2H
Set the voltage upper limit in CR mode
C3H
Enquire the voltage upper limit in CR mode
C4H
Set the voltage lower limit in CR mode
C5H
Enquire the voltage lower limit in CR mode
C6H
Set the current range in list mode
C7H
Enquire the current range in list mode
D0H
Set step counts of autotest file
D1H
Enquire step counts of autotest file
D2H
Set short steps
D3H
Read short steps
D4H
Set pause steps
D5H
Enquire pause steps
D6H
Set the on-load time of single step
D7H
Enquire the on-load time of single step
D8H
Set the delay time of single step
D9H
Enquire the delay time of single step
DAH
Set the no-load time of single step
DBH
Enquire the no-load time of single step
DCH Set autotest stop condition
DDH Enquire autotest stop condition
DEH
Set autotest chain file
DFH
Enquire autotest chain file
E0H
Save autotest file
E1H
Recall autotest file
0EH
Set Von mode
0FH
Enquire Von mode
10H
Set Von point
11H
Enquire Von point
If control output of electronic through PC, please setting electronic load to PC control state.
Command is 20H. Make a calibration on input of electronic Load, Ensure the calibration protection
mode is OFF state when setting calibration information.
If electronic load in calibration mode, user
can’t change the input and operation mode of electronic
load.
4
.
From 4
th
byte to 25
th
byte are information contents.
5
.
26
th
is checksum code, is the sum of the former 25 bytes.
NOTE