PAMSPAN501x G.SHDSL.bis EFM Gateway
-
97
3.
If to set the maximum and minimum line rate, input the Max Line Rate and Min
Line Rate respectively (where values range from 192 kbps to 5696 kbps) and then click
on
to submit your setting. After the handshaking between STU-R and STU-C
devices, the actual transmission rate will be presented in the Current TX Rate attribute.
4.
Click the line probe drop-down list to set line probe as enable or disable.
5.
Click the annex drop-down list to select the desired annex mode, including A and
B
6.
Click the PSD drop-down list to set PSD as symmetric or asymmetric.
7.
If to set the maximum and minimum line rate, click on the Max Line Rate and Min
Line Rate drop-down list respectively (range: 192 kbps to 5696 kbps).
8.
If to set the target margin, input the desired number in the target margin field
(range: -1 to 21 dB).
9.
Click on
to submit your setting or
to clear your setting.
10. To view the advanced status of SHDSL and Ethernet ports, refer to the system
status section as follows:
3.2.4.6
QoS
To configure the QoS, click QoS under “Configuration”. Below are some CLI
commands and the corresponding web images for setting up and configuring the EFM
for QoS function including some examples on how to add a classifier profile, scheduler
profile and attach them on target transports.