Italjet Dragster 2022, Maintenance Manual

Page: 160 / 165

•
Place the crankshaft half by giving
short taps with a rubber hammer.
•
Tighten the three screws to the pre-
scribed torque.
•
Trim the gasket protruding from the cyl-
inder plane.
Locking torques (N*m)
Crankcase EI fixing screws - M6x70 (1)
11 Nm
(8.11 lbf ft)
Crankcase EI fixing screws - M6x50
(2)
11 Nm (8.11 lbf ft)
See also
Refitting the
crankshaft
Oil pressure check
- Disconnect the electrical connection of the mini-
mum oil pressure switch and then remove the
switch.
- Check that the oil pressure reading is 1.8 atm
minimum with engine idling at 1700 +/- 100 rpm
and oil at the required temperature (wait for at least
one electric ventilation).
- Check that the oil pressure reading is between
3.5 and 6.5 atm with engine idling at 6000 rpm and
oil at the required temperature.
- Remove the specific tools on the engine once the
measurement is complete. Refit the oil pressure
switch and washer, tightening it to the prescribed
torque, and fit the flywheel cover.
- If oil pressure reading are not within the specified
limits, check in the following order: the oil filter, the
160