Seebacher GmbH
www.seebacher.de
Phone: +49 (0) 80 41 / 77 77 6
Marktstrasse 57, 83646 Bad Tölz
Fax: +49 (0) 80 41 / 77 77 2
5
9. Product description
The universal dimmer is suitable for the reliable operation of high-
voltage lamps, magnetic transformers, electronic transformers, ESL
and LED retrofit lamps. There are 2 separate dimmer outputs avai-
lable, each of which can be loaded with 700W. By configuration and
parallel connection of the outputs the dimmer can be loaded with
1x1400W. Each channel can be parameterized separately to the
corresponding load type (leading edge or trailing edge mode). The
dimmer automatically checks the connected load by carrying out a
short test after the operating voltage has been applied for the first
time to see whether the connected load can be operated with the
desired setting. The dimmer works with an internal dimming resolu-
tion of 16 bit and thus meets the highest demands. The properties
already predefined in the factory, such as dimming curves, minimum
and maximum limits, can still be changed and optimized by the user
himself. ISYGLT users can parameterize the functions as usual in
the ProgramDesigner. A free software tool is available for stand-
alone or DMX users. With this tool, the dimmer can be optimized
per parameter via USB or RS-485 data connection and internal data
such as temperatures, voltages, peak currents and power can be
displayed. In addition, an oscilloscope function is also integrated as
a new feature. This is the first time that the user has a tool for dis-
playing the current load - and this without dangerous measurements
on the mains voltage! A check of unknown illuminants - such as
new retrofit lamps - is thus possible without any additional measu-
ring equipment. All you need is the connected UD-700-X2 dimmer,
a USB cable (USB Type A to Micro B m/m) and our free software.
Inputs / Outputs
•
2 dimmer outputs 700W
•
2 control inputs 0-10V or 1-10V for „emergency operation“ or „stand-alone operation“
Design
•
plastic housing black, can be snapped onto 35mm DIN rail, 6 HP
Function displays in ISYGLT operating mode
LED state
Meaning
1 x LED (red)
OFF
No operating voltage
ON
Operating voltage, no error
steady blinking
Too high mains voltage (>400Vs)
3x blinking
No valid ISYGLT parameters available
1 x LED (yellow)
Operating voltage /
BUS
OFF
No BUS signal detected
ON
BUS signal detected, own address is not
detected
steady blinking
BUS signal and own module address detected
2 x LED (green)
OFF
Output „OFF“, no error
ON
Output „ON“, no error
steady blinking
Overtemperature
1x blinking
Overload
2x blinking
Overvoltage
3x blinking
Failure of communication with dimmer processor
Connections
•
1 voltage connection 230V, 45-65Hz
•
2 outputs 0-230V, max. 700W/VA each or 1x1400W/VA (both channels coupled)
•
2 control inputs 0-10V or 1-10V für „emergency operation“ or „stand-alone operation“
•
1 connection for the subnet (BUS A and B, RS-485)
