2-26
AUTOMATIC TRANS. CONTROLS,
CONTINUED
STARTING
Start the engine in either the “P” or the “N” position. The engine
should not start in any other selector position. If it does, something is
wrong. Have your truck checked by your dealer as soon as possible.
Always apply either the foot brake or the parking brake before
shifting into any driving position. This will prevent creeping.
The engine should be running at idle speed when shifting from “P” or
“N” to one of the driving positions. Always rotate the manual idle speed
control knob fully counterclockwise before driving.
P: PARK
The “P” position is to be used with the parking brake.
The “P” position is one of the two positions (the other is “N”) in which
the engine can be started.
NEVER MOVE THE SELECTOR TO THE “P” POSITION WHEN THE
TRUCK IS IN MOTION.
R: REVERSE
Bring the truck to a complete stop before moving the selector to the
“R” position.
N: NEUTRAL
Automatic transmission — Driveshaft must be removed when towing
your truck.
The “N” position is used should it become necessary to tow your truck.
The engine may be started when the selector is in the “N” position.
D: DRIVE
The “D” position is for all normal forward driving.
If additional speed is required for passing, press the accelerator
pedal hard to the floor. The transmission will downshift at speeds
below about 55 MPH (88km/h) to provide greater acceleration.
Push the overdrive switch to the “ON” position for greater fuel
economy. The automatic transmission will continue to select the best
speed range for the vehicle (1st, 2nd, 3rd, 4th, 5th and 6th).
55702_Sec02-2_'08 08.2.12 9:46 AM Page 26
