Isotta ALPHA 7RIII, Instructions Manual

Page: 19 / 24

19
MANUAL MANUAL
ON
1 2 3 4
ON
1 2 3 4
If you have problems with strobes from SEA&SEA, INON, and Nikonos flash you
switch the 4 pin on
[OFF]
as indicated in the figure below .
To insert SYNCRO cords
- To attach a strobe via electrical sync cord you have to use the bushings with
syncro socket placed on the side of housing.
N.B.
A bulkhead cap or sync cord must be attached to the housing for waterproof
operation. Never submerge the housing without either a sync cord or waterproof
bulkhead cap attached.
-Remove the bulkhead cap by unscrewing the plug inserted into the socket
anticlockwise (to the left) with the help, if necessary, of a screwdriver or a coin.
-Line up the pins and receptacles and insert the sync cord plug into the housing
bulkhead. Attach the other end of the sync cord to the bulkhead on your strobe.
Then tighten the ferrule that acts as a safety.
Once the use of the flash is completed we recommended to remove the cable
connector of the flash from the attach and proceed with the closing of the plug.
Before buying a flash make sure it can be matched with the camera housing.