11
NB:
*
Remove any straps and eyelets from the camera as seen on page 8
1.
REMOVE THE BACK FROM THE FRONT
Apply a slight upward pull to the locking knob and rotate anticlockwise until the
pin is visible. Slightly lift the Back until it comes out from the guide pin on the knob.
Remove the Back slantwise, paying attention to the two pins on the opposite side.
2.
It is very important to lift the
SELECTOR AF/M
on the left of the housing before
placing the camera inside.
3.
Put the camera on the slide tray and screw it unto the try until it is steady.
Insert the camera attached to the slide into the interior of the housing.
Run the slide on the guides from the front up to the stop.
4.
Insert the hotshoe contact before closing the housing.
N.B.:
Check that the hotshoe contact cable is inside the housing and is NOT
caught between the Back and the Front.
5. CLOSE THE BACK.
Check that the O-rings seals are in place, intact, clean and properly lubricated.
Insert the two lower pins of the bottom in the specific slot.
Insert the pin in the guide of the closing knob; turn the knob until the closure is done
and snap the safety by pressing it slightly down.
6.
Reposition the
SELECTOR AF/M.
QUICK START GUIDE
Summary of Contents for ALPHA 7RIII
Page 2: ...2...
