MEASUREMENT AND ASSEMBLY MANUAL
Instruction validity: as of 1 August 2013
4
Take special precautions if using drills, where the component being drilled must be held by a hand. To attain
higher output and lower drill bit break rate in portable drills, it is necessary to hold the tool while positioning your
arm in a line with the tool axis.
DURING USE
NOTE: Do not block the roller blind when moving. Put your hands outside the box vicinity before operating the roller blind.
Prevent children from playing with the control devices. Any remote controllers should be kept out of the reach of
children.
Check the roller blind regularly for deformation, excessive wear or other damage.
Do not operate the roller blind during maintenance works (for instance, window cleaning).
When using automatic control systems (for instance, sun/wind sensors), unplug the power cord before executing
any activities or maintenance on the roller blind.
Forced operation can cause damage to the roller blind.
Check proper roller blind function regularly.
Do not use the roller blind, if maintenance is necessary.
5. UNPACKING
The SCREEN GW
system is supplied partially assembled, only the guide bars or cord, accessories and ceiling brackets
are packed separately. After removing the packaging material, check the roller blind for completeness and eventual visible
damage to the components (upper box, guide bars, etc.). If unsure,
do not use the roller blind
and contact the seller.
NOTE: The packaging contains a box with accessories. All packaging materials (plastic sacks, polystyrene foam, nails,
screws, wooden elements, etc.) are potentially dangerous, and therefore must be kept out of the reach of children.
6. INSTALLATION
Installation works must be carried out solely by qualified personnel capable of adhering to all instructions stated below with
full consideration of their safety and that of all other persons.
The main activities include:
1) preparation of walls, ceilings, windows or other structures for the installation of roller blinds while using portable drills
and screwdrivers;
2) roller blind installation to a wall or ceiling;
3) connection to power mains;
4) adjustment (of end stops / end switches, etc.) and testing of the roller blind.
