15
To select the
Focus Offset
, press the
ENTER
button to show
FOCUS OFFSET
on the display.
Use the
DOWN
and
UP
buttons to adjust the value from 0 to 255, press the
ENTER
button to
store. Press the
MENU
button to exit.
4. How To Control The Unit
There are three ways to control the unit:
1. Master/slave built-‐in preprogram function
2. Easy CA-‐8 controller
3. Universal DMX controller
You do not need to turn the unit off when you change the DMX address, the new DMX address
setting will take effect immediately. Every time you power the unit on, it will move all the motors
to their ‘home’ position and you may hear some movement noises for about 20 seconds. After
that the unit will be ready to receive DMX signal or run the built in programs.
4.1 Master/Slave Built In Preprogrammed Function
By linking the units in master/slave connection, the first unit will control the other units to give an
automatic, sound activated, synchronized light show. This function is very good when you want an
instant show. You have to set the first unit in master mode
Show Mode
and select
show 1
,
show 2,
show 3
or
show 4
mode. Its DMX input jack will have nothing plugged into it, and Its master LED
will be constantly on and sound LED will flash to the music. The other units will be set in
slave
mode
and select
Slave 1
(normal) or
Slave 2
(2 light show) mode, Their DMX cables plugged into
the DMX input jacks (daisy chain) and the slave LED lights will constantly on.
2-‐light show
In
slave mode
,
Slave 1
means the unit works normally and
Slave 2
means 2-‐light show. In order to
create a great light show, you can set
Slave 2
on the second unit to get contrast movement to
each other, even if you have two units only.
Summary of Contents for iMove 350SR
