9-
Display Inversion
It is good for you to install the unit on the floor or under ceiling. Press the
MENU
button up to
when the
is blinking on the display. Use the
ENTER
button to change to the mode
(display inversion), It will automatically store after 8 seconds. Or press the
ENTER
button again return to the mode
(display normal). To go back to the functions press
the
MENU
button.
Display normal mode for the fixture putting on the floor.
Display inversion mode for the fixture fixing under ceiling.
Focus Adjust
Press the
MENU
button up to when the
is blinking on the display. Pressing
ENTER
button, the unit will focus on tilt 90
°
, and then the unit will focus on pan 0
°
, pan 90
°
, pan 180
°
,
pan 270
°
in every pressing
ENTER
button. Use
DOWN
and
UP
button to adjust focus. To go
back to the functions press the
MENU
button again.
Self-Test
Press the
MENU
button up to when the
is blinking on the display. Pressing
ENTER
button and the unit will run self-test by built-in program. To go back to the functions press the
MENU
button again.
Fixture Hours
Press the
MENU
button up to when the
is blinking on the display. Pressing
ENTER
button and the display will show the number of working hours of the unit. To go back to the
functions press the
MENU
button again.
Reset
Press the
MENU
button up to when the
is blinking on the display. Pressing
ENTER
button and all channels of the unit will return to their standard position. To go back to the
functions press the
MENU
button again.
4.2 Main Function
To select any of the pre-set functions, press the
MENU
button up to when the required one is
shown on the display. Select the function by
ENTER
button and the display will blink. Use
DOWN
and
UP
button to change the mode. Once the required mode has been selected,
press the
ENTER
button to setup or it will automatically return to the main functions without
any change after idling 8 seconds. To go back to the functions without any change press the
MENU
button. The main functions are shown below:
MENU
Focus Adjust
Self-Test
Reset
Fixture Hours
Display Inversion
Display Normal
Tilt Inversion
Tilt Normal
Pan Inversion
Pan Normal
Split Color
Normal Color
Show mode 4
Show mode 3
DMX512 Address Setting
Blackout Mode " No Blackout "
Blackout Mode " Yes Blackout "
Slave Mode " Normal "
Slave mode " 2 Light Show "
Show mode 1
Show mode 2
LED off
LED on
Dimmer Normal
Dimmer Inversion
DMX512 Address Setting
Press the
MENU
button up to when the
is showing on the display. Pressing
ENTER
button and the display will blink. Use
DOWN
and
UP
button to change the DMX512
address. Once the address has been selected, press the
ENTER
button to setup or
automatically return to the main functions without any change after 8 seconds. To go back to
the functions without any change press the
MENU
button again.
