10F
Dimmer offset
Press the
MENU
button for at least 5 seconds into offset mode, use
DOWN
and
UP
button
up to when the
is shown on the display. Pressing
ENTER
button and the display will
blink. Use
DOWN
and
UP
button to adjust the dimmer home position. Once the effect has
been selected, press the
ENTER
button to setup or automatically return to the offset
functions without any change press the
MENU
button again, To go back to the main
functions without any change after 8 seconds.
5. How To Control The Unit
Two ways to operate:
1. By universal DMX controller
2. By dedicated controller
No need to turn the unit off when you change the DMX address, as new DMX address
setting will be effected at once. Every time you turn the unit on, it will show 1200 on the
display and move all the motors to their ‘home’ position and you may hear some noises for
about 20 seconds. After that the unit will be ready to receive DMX signal.
5.1 DMX Controller
If you use a universal DMX controller to control the units, you have to set DMX address from
1 to 512 channels so that the units can receive DMX signal.
Press the
MENU
button up to when the
is shown on the display. Pressing
ENTER
button and the display will blink. Use
DOWN
and
UP
button to change the DMX512 address.
Once the address has been selected, press and keep
ENTER
button pressed up to when
the display stops blinking or storing automatically 8 seconds later. To go back to the
functions without any change press the
MENU
button again.
Please refer to the following diagram to address your DMX512 channel for the first 4 units.
6 Channels
：
11F
5.2 Dedicated Controller
IF-series has 6 channels for international protocol DMX512. It can finish all operations via
dedicated controller without using other controllers. When the power is switched on, the
projector automatically starts to run the self-test. After finishing these, the fixture is ready for
operation.
1.
DIMMER OPEN buttons
: Holding the buttons, the light beam will become more stronger
and stronger, then shutter will obtain max. value. After un-holding it, the light beam and
shutter resumes its initial condition. There are 2 buttons on the both sides of the controller
for your convenient operation.
2.
IRIS OPEN buttons
: Holding the buttons, the light iris will become more bigger and
bigger. After un-holding it, the light beam resumes its initial condition. There are 2 buttons
on the both sides of the controller for your convenient operation.
3.
FIXED COLOURS & RAINBOW switch
: Turning the switch on the RAINBOW position,
enable the rainbow function, you can set different rainbow speed by pressing
COLOUR
buttons
from slow to fast. Turning the switch on the
FIXED COLOURS
position, enable
the fixed colors function and disable the rainbow function. They will save last setting
automatically in each step.
4.
COLOUR buttons
: There are 9 color buttons of white, red, yellow, magenta, green,
orange, blue, pink and purple. Select the light beam colors by pressing the relative color
buttons.
5.
COLOUR TEMPERATURE switch
: Adjusting this switch to obtain 3 kinds of color
temperature: Standard 6000K, 5600K and 3200K.
