Page 4
1. Secure spider plate to the junction box (screws supplied with the junction box). Route the
transformer’s secondary leads through the center knockout of the rear panel then level the rear panel
before tightening the panel to the spider plate via the knock-outs.
2. Place the filler plates in the rear panel as per Detail B below.
3.Terminate transformer leads to the sign per Detail A below.
4. Install the light guide assembly. The transformer leads are to be routed within the rear panel and the
white reflector is to be located in-front of the wires as show below. The wires should not be visible
when looking at the sign from the front face.
5. Snap on Front Panel with desired directional indicators removed per Section 1.
SECTION 2: BACK MOUNT INSTALLATION (SINGLE FACE SIGN)
Figure 6: Back Mount Installation
2X screws
supplied with
J Box
Filler Plate (See Detail B)
Front Panel
Light Guide Assy
w/ Photo-luminiscent Panel
Rear Panel
Green film
(Transparent)
white reflector (far side)
Optional Security Enclosure
(Single Face)
Refer to Instructions supplied with
security enclosure for full assembly
details.
Detail A
White reflector
Transformer
lead wires
Transformer Connectors
Remote Option Conn
Used in all other applications
“Thicker” side clip is supplied when a
single face security enclosure is ordered.
Outline shown below is used in all other
applications.
Detail B
transformer secondary leads
Z410138 Rev B