www.ismacontrolli.com
pag. 4
DBL561en | 1
st
Issue rev. c | 03/2022
MAINTENANCE
The actuator is maintenance-free.
ACCESSORIES
DMVE
End point auxiliary switches
GMVE
Thermal insulation for MVE actuators *
GMVES
Thermal insulation for MVE.S actuators *
KIT-P13.5
10 cable glands kit (nuts and gaskets included)
KIT-T13.5
Kit 10 caps for cable glands hole (nuts and gaskets included)
248
Stem heater 24V, 50W (suggested when the fluid temperature is below 0°C) *
* It is not possible to install both thermal insulation (Gxxxx) and stem heaters.
COMPATIBLE VALVES AND ACTUATORS
iSMA CONTROLLI VALVES
MVE2XX-65
MVE2XXS-65
Current iSMA CONTROLLI valves
(except for 2-3TGB.F PN16)
●
-
VSXT09PBP, VSXT10PBP
-
only with MVE204S-65
2-3TGB.F PN16
-
●
iSMA CONTROLLI valves with threaded
M40 connections (except for VSB-VMB,
VSB.F-VMB.F PN16)
with AG51
-
VSB-VMB, VSB.F-VMB.F PN16
with AG52
with AG63
OTHER MANUFATURERS VALVES
MVE2XX-65
MVE2XXS-65
Belimo H2..X-S and H3..X-S
with AG82
with AG82
Siemens *
with AG70-10
with AG70-14
-
Danfoss (VR/VF (S) models)
with AG60-07
-
TAC DN15-V298
with AG60-08
-
TAC DN15-V2XX/V3XX
with AG60-09
-
Honeywell **
with AG60-10
-
Airtek
with AG60-11 with AG60-12
-
Johnson Controls VB7816-2111
with AG66
-
Johnson Controls BM-3018-3300
with AG67
-
MUT MK DN50-150
with AG69
-
Tac Venta
●
-
* AG70-10 for valves having stem Ø 10mm AG70-14 for valves having stem Ø 14mm
** valid for the following models M6: V176A,B, V538C 1/4”: V5011A
ELECTRICAL CONNECTIONS
Remove the cover screw with a screwdriver and then remove the
cover as shown in the picture beside.
MVE2xx-65 is equipped with a 6 poles removable terminal block
for actuator control and with a not removable 2 poles terminal
(F and N) for main control; the each pole of the plug is clearly
marked and the same label are reported on the electronic board.
Before powering up the actuator make sure the plug is properly
connected to the electronic board and the label on the plugs and
on the board match.
Use cable gland IP65 PG13,5 model.
