User manual iSMA-B-AAC20/M-Bus Network
Version 1.2
www.globalcontrol5.com
Page 3 / 13
1 Introduction
This manual contains information about an M-Bus protocol in the iSMA-B-AAC20 controllers.
M-Bus devices can be connected directly only to the iSMA-B-AAC20-M hardware version
with the M-Bus interface (max. 20 devices) and with firmware version 5.1 and above. The M-
Bus devices can also be connected to all iSMA-B-AAC20 controllers with firmware 5.1 and
above using M-Bus-IP gateway.
1.1
Revision History
Rev
Date
Description
1.0
22.11.2016 First edition
1.1
20.04.2017
Added action “Reset Stat” in
the network components
1.2
27.01.2020
Replaced environment of programming from Workplace to
iSMA Tool
Table 1 Revision history
2 M-Bus Kit
To serve the M-Bus protocol (connected either to the Local interface or by the IP gateway)
the iSMA-B-AAC20 controller uses the iSMA_MBus kit.
2.1 Installation of the iSMA M-Bus Kit
To install the M-Bus kit, import the kit to the iSMA Tool software (possibly as part of the
package of the various kits in a zip file). To do this, use an application from the Sedona ->
Import Sedona Files.
After a successful import of the files, upload them to your device using the Kit Manager
Application from the Sedona Tools package.
WARNING! Before programming the M-Bus Network, please check if the latest kit version is
used. The latest kits are available at GC5 support web site: www.support.gc5.pl
