Manufacturer of Quality Air Conditioning and Heating Products • www.islandaire.com • sales@islandaire.com • (800)-886-2759
33
Electrical Installation
Hardwire Kit
Part Number 6040756
Cord connection to a wall socket is not permitted for 265
volt units. All 265 volt units must be hard-wired using
the hard wire kit or make use of the plug-in receptacle in
the standard subbase.
LCDI Cords
230/208V units are equipped with LCDI or AFCI power
cords and can open the electrical circuit to the unit. In
the event the unit does not operate, check the reset but-
ton located on or near the head of the power cord as part
of the normal troubleshooting procedure.
PTAC Wire Harness Kit
See PTAC Wire Harness Kit Installation Instructions
for proper wire orientation and location for low voltage
wiring.
Heaterless Units
Refer to the Installation Instructions supplied with the
kit for a complete description of the installation proce-
dures. All 208/230 volt heaterless units are shipped with
a 15 Amp
power cord.
Voltage Measurements
Once the unit is properly wired, measure the unit
supply voltage. Voltage must fall within the voltage utili-
zation range as shown in the table below.
OpERATING VOLTAGE
UNIT VOLTAGE
RATING
VOLTAGE UTILIZATION RANGE
mINImUm
mAXImUm
230/208
197
253
265
238
292
Figure 35
Hardwire Kit
Figure 36
LCDI Cord
