8
Find a flat area, near the water, where you
plan on installing the water trampoline.
Lay out the frame sections in a circle and
slide the ends together.
Then insert and
screw together each section using the
enclosed bolts. When finished you will
have a flat round frame. (See photo
)
Trampoline Frame Assembly
Next, lay the jump surface in the center of
the frame. Attach the jump surface to the
frame by hooking the spring to the V-ring
on the mat and the other to the slot on the
frame. Start with 4 springs and attach one
at 12:00, 3:00, 6:00 and 9:00 counting the
slots to be sure they are lined up evenly.
When installing the springs the hooks
should be pointing towards the ground.
Tip: spread a supply of springs around the
outside of the frame and pull toward you.
Count the number of slots between the
4 springs and fill in evenly with springs
midway in each section. Continue until all
springs are installed.
Failure to properly install the springs
can result in personal injury. Make
sure each V-ring on the jump mat is
attached to a spring and the spring is
firmly in a slot on the steel frame.
WARNING
