4
Wall Panel Terminal Mounting Brackets (2)
Mounting
Screws
(4)
Mounting Instructions: Flush Wall Mount
Two mounting flanges with screws are provided with the
unit. Attach flanges as shown. Flanges can be affixed to
any two corners of the unit. Then, fasten unit between two
(2) wall studs. The face of the box should be even with the
face of finished wall surface. After mounting unit, protect
interior of box from construction debris.
CAUTION: Provided mounting hardware must be used.
Mounting Instructions: Casework Mount
Two mounting flanges with screws are provided with unit.
Holes are slotted to permit adjustments for variations in
cabinet material thickness. Attach flanges as shown in
figure above. Make cutout in desired location in casework
to permit wall unit to pass easily into opening. From within
the cabinet fit into opening and fasten unit to back of
casework. Face of wall box should be even with face of
cabinet. After mounting unit, protect interior of box from
construction debris.
CAUTION: Provided mounting hardware must be used.
Mounting Instructions: Surface Mount
In order to surface mount the unit, it is necessary to attach
the provided brackets to the rear of the housing. Care should
be taken to verify that the mounting means securely fastens
the unit to the wall surface. A stainless skirt is provided in
order to conceal the wall box from view.
CAUTION: Provided mounting hardware must be used
Mounting the Wall Panel:
•
Verify that Unit is wired with junction box cover in
place.
•
With the Door open, position the Wall Panel over the
Wall Box as shown.
•
Holding panel in front of box, affix panel to box using
four (4) 8-32 stainless screws
•
Close the panel and lock.
CAUTION!
Do not install the panel until all wall finishes
are complete.
Output
Terminal
Wall
