STEP
DISPLAY
PROCEDURE
10.
11.
12.
If you put 200gm weight, Enter
“200.000”. Change the rightmost digit
by pressing the UP button. Shift the
changed digit to left by pressing the
“shift” button once. Enter the value as
shown using the key combination.
Press the mode button once again now
you will see “CAL- F” for one second and
you will see the full load counts.
Press the mode button and you should
see “UNLOAD” on the display. Lift the
weight from the pan and press the mode
button to finish the calibration. The
m a c h i n e s h o u l d r e s t a r t n o w
automatically.
ITA Series – Table Top Precision Weighing Balance
ITA Series – Table Top Precision Weighing Balance
4 USER OPERATION
4.1
SWITCHING SCALE - ON / OFF :
The scale is switched ON / OFF by
using the Power switch located on the right side of the scale.
Note :
Make sure the weighing pan is empty before turning on the
scale.
4.2
TARE / ZERO :
The machine has a common Tare/Zero button. TARE
/ ZERO BUTTON : This button is used for taring a weight to display
0.000. Place a container on the weighing pan (say 200g), then
press the TARE button. The weight is zeroed and the machine will
display zero.
4.3
ACCUMULATION :
Keep a weight on the weighing pan(ex 200g).
The display will show the weight. Now press UP. The display will
show M PLUS. Now keep another weight (ex 300g), the display will
show its weight. Now press UP button. To recall the weight press
the shift button.
4.4
MODE :
This button is used to select the different units of weight
available in the scale, that is to choose between the units of carat,
tola, piece counting and gram.
4
9
