ISHIDA IP-EMZ, Service Manual

Page: 100 / 176

Chapter 4 SYSTEM MODE
IP-EMZ Service Manual 4-21
Buttons/Display Fields Function
Preprint Feed Set the preprint feed length.
Press after numeric entry to set the feed length.
The data range is 0-999 (0.0 mm – 99.9 mm on the screen).
Default data: 7.5 mm
Feed End Length Displays the set feed end length (unit: mm).
Press after numeric entry to set the feed end length.
The data range is 1-999 (0.1 mm – 99.9 mm on the screen).
Default data: 3.0 mm
The label is issued leaving the set length behind and fed immediately before
the label is sucked.
Print Direction “Normal rotation” and “Reverse rotation” can be set as the label print
direction.
The selected item will change color to blue.
Default data: “Normal rotation”
Back Feed Select the back feed availability at the start of label printing.
The selected item will change its color to blue.
Default data: “Yes”
When “Yes” is selected the label is back fed in the above-mentioned preprint
feed length and printing starts.
Make sure “Yes” is selected at all times.
Sensor Type Set the label feed availability using the label sensor control.
Press after numeric entry to set the sensor type.
Press without numeric entry to display the pop-up screen. Press the desired
button to make a selection.
Default data: “1” (Label sensor)
Sensor Distance Set the distance between the label sensor position and the printer head end.
Press after numeric entry to set the distance.
The data range is 0-999 (0.0 mm – 99.9 mm on the screen).
Default data: 17.5 mm
The label feed amount will increase when the data is increased, and
decrease when the data is decreased.
Printing Speed Set the label print speed.
Enter either “1” or “2” (1:80mm/sec 2:100mm/sec) and press this button.
Press without numeric entry to display the pop-up screen. Press the desired
button to make a selection.
Default data: “2” (100 mm/sec)
Printing Density
(0 - 9) Set the print density when using the monochrome thermal head.
Press after numeric entry to set the density.
The data range is 0-9. (0: lightest 9: darkest)
Default data: “5”
2 Color Print Density
(0 - 9) Set the print density for black and red when the two color thermal head is
used.
Press one of these buttons after numeric entry to set the density.
The data range is 0-9. (0: lightest 9: darkest)
Default data: “5” for both black and red
Print Check Format No. Set the test print format.
Press after numeric entry to set the number.
The data range is 1-99.
Default data: 52 (37 x 60 mm) for printers #1, #3, and #4
20 (55 x 60 mm) for printer #2
Format Information Displays the label size of the set default format number.
Confirm that the set format number is correct.
This function is display only and the data cannot be changed.
Item No. Set the test item number for print confirmation.
Press after numeric entry to set the number.
The checker pattern is printed when the item number is “0.”