ICV 4030 - CNC-Compact-Machine with CAN Controller
Page - 4
S
4 Cleansing / Maintenance
Before turning off the machine push the master switch to open the hood. Afterwards it will
not be possible.
Before cleansing and/or maintenance of the machine, always turn off the master
switch and pull the mains plug in order to avoid the turning on by mistake.
-
Regularly clean the machine from all chips by using a brush or a vacuum cleaner (do
not apply compressed air). This will preserve the mechanical parts from early wear.
-
It is advisable to regularly remove the covering plate of the Y-axis underneath the T-slot
plate in order to remove possibly penetrated chips or dusts at bigger volumes of chip
production and when the chips are very fine.
-
The sealing lips come with a Teflon component. Particular maintenance is not required.
-
Clean the plastik washers with a non-abrasive liquid cleaning agent.
The guiding rails as well as the drive shafts are provided with a long-time greasing ex
works. Regrease them after 500
– 1000 working hours, according to the applied load.
You may use common roller bearing grease for that purpose. All guiding rails and shafts
are greased with the soda soap grease GP00/000F-20 according to DIN 51 502. In case
you use oil, lubricate regularly every 100
– 200 working hours. In order to grease the
drive shaft, first do a reference move then open the hood and last turn off the machine.
To grease the Y-axis move the T-slot plate all the way to the front* and unscrew it from the
Y-axis ( 6 screws).
Remove the plastic plug underneath. Grease through the now visible lubricator nipple.
The guiding rails are accessible through the sealing lips.
To remove the cover plate of the Y-axis, release the fixing screws all around.
inicates in all drawings the access to the points to grease.
