Iseki TXG237, Operation Manual

Page: 46 / 98

OPERATION
45
Attaching Implements
CAUTION: Always use POSITION CON-
TROL to attach/detach implements to
provide precise control of hitch.
FIG. 4-17: Back Tractor to implement, centering Trac-
tor with implement hitch frame.
Raise or lower hitch using position control lever, 1,
and align left lower link end with corresponding imple-
ment attaching pin.
Lock the brakes, shut off engine and remove key.
FIG. 4-18: Side ball end of left lower link, 1, over
implement pin and secure with linch-pin.
Adjust height of right lower link using leveling turn-
buckle, 2. Attach and secure right lower link, 3, to
implement with linch-pin.
Attach top link, 4, to top of implement hitch frame
using pin supplied with Tractor. Rotate center barrel
section of top link, to lengthen or shorten it, and level
implement from front to rear.
After the implement is attached, it can be readjusted
for level operation using leveling crank and top link.
Secure all adjustments.
IMPORTANT: With some mounted implements, it
will be necessary to remove drawbar
at rear of Tractor to permit implement
to be raised and lowered without ob-
struction.
Certain implements require minimal side-play. Stabiliz-
ers, 5, at each lower link should be evenly adjusted to
reduce side-play to desirable level. Do not remove all
side-play as lower link damage may result.
NOTE: The amount of side-play (stabilizer loose-
ness) is dependent upon implement and type
of operation.
Normally 50mm of total side movement is de-
sired, 25mm to each side of Tractor centerline.
1
4
5
2
3
1
FIG. 4-17
FIG. 4-18