Iseki SCMA48F, Introduction Manual, Page: 41 / 52

CHAPTER 9. SMM54 INSPECTION AND MAINTENANCE OF MAJOR PARTS
41
9
CAUTION: Be sure to replace the removed
covers after cleaning.
b. Each blade shaft end and tension pulley end are
equipped with a grease fitting. Inject grease through
these fittings periodically and make sure that each
part rotates smoothly.
c. After mowing, clear the underside of the mower
deck and blades from accumulated grass and dirt.
Especially after operation in wet grass, wash them
without failing, or accumulated wet grass and dirt
will cause performance deterioration.
7. PERIODICAL INSPECTION TABLE
IMPORTANT:
・
Above mentioned service intervals should be used as reference criteria. If working conditions are harder, earlier
service is recommended.
・
When special technology and special tools are required, consult your dealer.
○
Check points Intervals after that Judgement criteria
Inspection and
servicing intervals
(hours of operation)
Pre-
operation
50 100 150 200 250
Blade
Gear case oil
Belt tension
Inflation of
gauge wheel
Replace after initial 50 h. and
then after every 200 h.
Deformed, broken, worn,
and cracked ones should be
replaced.
Maintain the specified level.
Inter-coil clearance:
1.2 -1.4 mm (0.05 -0,06 in.)
● ○ ○ ○ ●
○
△
○ ○ ○ ○ ○
○ ○ ○ ○ ○
Clean after every 50 h.
Clean after every 50 h.
Grease up after every 50 h.
There should be no lost or
deformed ones.
1.5 kgf/cm
2
There should be no grass or
dust accumulated.
Criteria for replacement:
・ Deep crack over half the
thickness of belt.
・ Worn out side wall canvas
There should be no loose ones.
They should turn smoothly.
Rollers and gauge
wheels
Belt cover inside
Belt
Greasing points
Bolts and nuts
Pins and crips
○
○
○
○
△ △ △ △
○ : Inspection, replenishment, and adjustment △ : Cleaning and washing
● : Replacement ★ : Consult your dealer.