ise smart connect KNX Hue
Commissioning
Order No. 1-0002-003
Product Manual Page 47 (60)
5% to 100%
A fixed switch-on brightness can be defined in 5% increments.
ETS setting (default setting)
The value parametrised in the ETS is used for the switch-on brightness
(compare Chapter 5.4.2 Light parameter tab).
Dimming behaviour
in absolute bright-
ness
Dimming
The required absolute brightness is dimmed at the configured dimming
speed.
Jumping
The required absolute brightness is set in the light source as quickly as pos-
sible.
Philips Hue behaviour
The same setting is used to configure a brightness as in the mobile Philips
Hue app (currently 400ms). This allows lights to respond with a visually ap-
pealing glow.
ETS setting (default setting)
The value parametrised in the ETS is used for the switch-on brightness
(compare Chapter 5.4.2 Light parameter tab).
The corresponding line is highlighted in yellow as soon as you change a light's configuration. You can
used the "Save" button under the table to apply the change.
The "Delete" button clears all light assignations. If you click on "Save" now, the device will delete any
saved configuration and generate a default configuration. The default configuration fills the configured
KNX light assignations with the lights available in the registered Hue Bridges until all KNX light assigna-
tions are taken and/or no more Hue lights are available.
Note: The default configuration is not saved automatically. The default configuration will also change if
a Hue Bridge is not available or lights are added or removed.
