GLS Sampler
1-6
1.7 Installing a Power Source
The GLS must be powered by a 12-Volt DC
power source. Isco recommends using one of the
following Model 900 series power sources:
• Batteries -
· Model 934 Nickel Cadmium Battery,
4.0Ah
· Model 946 Lead-Acid Battery, 6.5Ah
• Power Packs -
· Model 913 High Capacity Power Pack,
120 Volts AC
· Model 923 High Capacity Power Pack,
240 Volts AC
· Model 914 Battery Backed Power Pack,
120 Volts AC
· Model 924 Battery Backed Power Pack,
240 Volts AC
1.7.1 To install an Isco Model 900 power
source:
1. Place the power source into the center
section recess.
2. Secure the power source by pulling the
elastic bands over it and attach the clip to
the two posts. Note that there are two sets
of holes - use the set that places the clip
against the power source.
3. Attach the two-pin connector to the Input
Power connector on the back of the
controller.
Summary of Contents for GLS
Page 2: ......
