ISA ZERO TOUCH T12, Use And Maintenance Manual

Page: 56 / 72

16 of 30
If the temperature controlled cycle is not completed in the allotted time, this problem will be signalled by the
appearance of the alarm icon, but the blast chilling cycle will still continue.
In temperature controlled cycles, pressing the key will bring up the screen granting access to the
following functions.
heat needle probe to remove it from the product;
record the cycle just performed in the memory.
At the end of a time controlled cycle, the initial screen for the blast chilling/blast-freezing modes will appear.
4 SPECIAL CYCLES MODE
Press this area on the Home page to Special cycles.
Some functions are available only via parameter
configuration or HW optional.
Note If both the sterilisation and the needle probe heating cycles are
enabled, two alternatives will appear on the special cycles page,
according to the temperature indicated by the needle probe: if this
temperature is below -1°C, an icon will appear to select the needle
probe heating option, if it is above 0°C, the sterilisation icon will
appear.
Pressing this area enables selection of a fish sanitation cycle (a function always shown);
see section 4.1.
Pressing this area enables selection of a thawing cycle (a function always shown); see
section 4.2.
Pressing this area enables selection of a manual defrost cycle (a function always
shown); see section 4.3.
Pressing this area enables selection of an ice cream hardening cycle (a function always
shown); see section 0.
Pressing this area enables selection of a sterilisation cycle (a function activated by
parameter); see section 4.5.
Pressing this area enables selection of a needle probe heating cycle (a function
activated by parameter if at least one needle probe is being used); see section 4.6.
Pressing this area enables selection of a drying cycle (a function activated with the door
closed); see section 8.7.
Pressing this area enables selection of a proofing cycle (a function activated by
parameter); see section 4.8. Parameter E12, with optional module
Pressing this area enables selection of a slow cooking cycle (a function activated by
parameter); see section 4.9. Parameter E12, with optional module